![]() ° I've tried taking the cmos battery out, waiting even about an hour and put it back in. I've also tried to put 1 singular stick in a slot. ![]() ° I've taken out my ram and rubbed an eraser on the pins gently. ![]() Also I believe I readjusted this to have to see the bios because I had a similar problem with the display showing no signal. ° Readjusted my graphics card (I can't take it out fully since it's still on a loop) I've blown compressed air in the slot. But here are some things I have tried from reading around. My setup is watercooled so I have to be very careful and can't take things out of the system that well. I'm not the most tech savy but I looked around to see if I could solve my problem and hopefully its not crucial or detrimental. Since then my computer shows no signal on the display(it also turns on when I turn my computer on) and my keyboard does not light up but everything else like the fans, my rgb, and my loop they all run. I then heard the computer shut off, turn back on and then shut off again. Everything was running perfectly fine and I had to readjust my fans rgb hud because only 3 fans were being lit out of 6. I have completed my build and I actually had it running yesterday in fact.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |